360-icon download left-arrow left-doublearrow nav-dot pdf-icon rss-icon search-icon spot-icon subnavi-icon close-icon info-icon

More torque and less breakage.

With a working width from 4.20 m to 6.00 m, the FreeFlow table can tackle all kinds of conditions. It is especially stable and maintenance-friendly because the components are bolted on. With 1,220 cuts per minute, the high speed of the cutterbar ensures a clean cut and a low power requirement. Then the large intake auger, with a diameter of 580 mm, moves the crop swiftly and uniformly to the crop elevator – best conditions for maximum area coverage and the best harvesting results.

Intake auger

The FreeFlow table has feed fingers over the entire width, which increase the output of the intake auger and guarantee active, fast feed into the crop elevator.


The optional multi-coupler permits fast turnarounds when changing fields.

Schuhmacher knife system

The Schuhmacher knife system is the best in the industry. With 1,220 cuts per minute, it is selfcleaning and always remains sharp.

The Threshing system

High-capacity threshing cylinder

The threshing cylinder on the 5185 E has a 600 mm diameter for high inertia and performance. Eight counter-rotating threshing bars effectively separate the grain during the threshing process. Both the grain and straw are handled very gently and breakage is minimised.

Robust grain concave

With one of the largest concave areas in its power class, the 5185 E drives in the large harvest volumes in the shortest time. The different wire spacings within the concave are the main reason for this: While the wire spacing in the front area is narrow to ensure intensive threshing, the wider wire spacings in the rear part of the concave permit a higher separation capacity.

Closed high-performance straw walker

After the threshing unit, the straw is effectively fluffed up over 4.30 m long straw walkers with a 150 mm stroke. Four 250 mm high steps create a loose straw mat, which permits residual grain to be separated perfectly in the huge separation area. The closed straw walkers distribute the grain uniformly over the entire width of the preparation floor for efficient separation.

ABC module
Threshing cylinder

Front and rear concave setting can be adjusted independently

Front perfect, the rear, too: the front and rear concave openings can be adjusted independently. You can adapt the threshing unit to any possible harvesting conditions from the comfort of the cab.

14 and 24 mm sectional concave variants

There are two front segments available for the quick-change sectional concave: 14 mm wire spacing for grain harvesting and 24 mm for maize harvesting.

Straw walker steps have active rear walls

The so called active, open rear walls of the steps further improve residual separation.

The next step to your Fendt E-Serie 5185